Description
The All-New FlashClean, formerly GHE FloraKleen
This one-of-a-kind soil conditioner and rinse removes salts from fertilisers in soil and coco.
In addition to assisting in the removal of excess nutrients, which can cause plant stress and even root damage, it also helps to dissolve bindings between the substrate and minerals, allowing the plant to utilise the remaining fertiliser, which is particularly crucial during harvest.
Use
Hydroponic systems that recycle their solution:
To revitalise before switching diet (especially before the FinalPart):
FlashClean is used at a rate of 1.5 to 3ml per litre, and after being circulated through the system for 24 hours, the old solution is drained and replaced with new.
The smaller dose should be used on young or delicate plants, while the greater dose should be used on mature plants that are close to harvest.
FlashClean should be added to pH-adjusted water at a rate of 1.5 to 3 millilitres per litre (you don't need to use a full tank, just enough to circulate freely and run the system) when a nutrient burn or lock-out has occurred.
Put it in circulation for a full day before draining it and replacing the nutrient solution. Apply the lesser dose to tender young plants and the higher dose to more robust mature plants.
After the final part, as a final wash:
FlashClean should be added to pH-adjusted water at a rate of 1.5-3ml per litre (you don't need to use a full tank, just enough to circulate freely and run the system).
Instead of losing scent with a long water flush, circulate for the final two days before harvest to raise sugar levels in your crop.
For use as a component of potting soil or soilless mix, including Coco Coir:
To recover from nutrient burn or lock-out, or to reset and refresh before switching nutrients (even before FinalPart),
After a lockout, every fifteen days, etc.
FlashClean should be added at a rate of 1.5 to 3 millilitres per litre of water. Soak until water begins to drain out of the bottom of the container.
Start applying fertiliser again the next time you water normally. Apply the lesser dose to tender young plants and the higher dose to more robust mature plants.
After the FinalPart, as a final wash:
FlashClean, used at a rate of 3 millilitres per litre of water, can be used in place of nutrients in the final two days before harvest to raise the crop's sugar content without wasting time or water on a long water flush, which would dilute the crop's perfume and medicinal properties.
Tips
Although FlashClean can be used whenever necessary, once every two weeks is maximum usage.
Sodium and other mineral salts are dissolved.
Cleans the substrate by rinsing it.
Apply to any medium For environmentally sound farming
For GHE Feed Chart, Refer Thereto.
